TruXedoPlus Toolbox & Soft Roll-Up Tonneau Cover Combo
The TruXedo Plus Toolbox and Tonneau Cover Combo has all of the features of a TruXedo soft roll-up tonneau cover, such as easy operation and tension control, with the added feature of lockable cargo storage.
Black powdercoated toolbox is 18" wide and 11" deep. Durable aluminum construction features
a continuous hinge and reinforced lid for strength. A skid resistant mat on the bottom keeps cargo from sliding. Toolbox will support 150 lbs of weight and is secured by a lockable push button latch.
Flat, low-profile bed cover is made with industrial strength vinyl fabric that is very high quality and has been tested in extreme conditions. It is UV-protected and will not fade in the sun. It also expands slightly in cold weather, so it is very easy to operate, even at 40° below zero! Cover will also support up to 350 lbs of snow or other heavy weight without bending or stretching. Available in black only.
The TruXedoPlus has a tension control system located in the toolbox, under the lid. There is a bolt on each side of the toolbox that can adjust the position of the toolbox. By adjusting the toolbox position, you can create more or less tension in the tonneau cover.
Velcro® seals help to keep rain, snow, and dust out of the bed of your truck with no snaps to freeze, stick, rust or break. Each kit includes two pieces of weather seal to be fitted into the front corners of the truck bed, further helping to keep elements out of the bed. There is also a seal between the toolbox and tonneau cover to reduce leaking.
Easy trigger latch on driver's side has a one finger release that opens quickly and easily. The rear header functions independently of the tailgate so there is nothing to remove when opening the tailgate. Cover completely rolls up and self stores in seconds and is just as easy to close. When closed, the TruXedo Plus tonneau cover cannot be opened without opening the tailgate which provides added security when used with a locking tailgate.
Typically, the TruXedoPlus can be installed in about 45 minutes. It requires a 9/16” wrench to tighten the 6 clamps that attach the side rails to the inside of the truck bed.
Click here to see installation videos.
The vinyl fabric on your tonneau cover can be cleaned with mild soap and water, and may be hand washed or safely cleaned in the car wash of your choice, and can be treated with any vinyl protectants made for tonneau covers. Never clean cover with petroleum or citrus-based products, and avoid silicone based protectants.
The unique inside mount design of the TruXedo Plus rails enables you to accessorize with most bed rails, bed liners, and rail caps. Can also be used with 5th wheel hitches. Simply roll the cover all the way open and secure with security straps at the front of the bed, which allows you full access to your 5th wheel.
The TruXedo Plus truck bed cover can also be used with bed extenders, but in order to use the bed extender, since the side rails of the cover extend 2-3/4” into the bed on each side, it must not come within 3” of the side of the bed when rotated, or it must be able to detach from the truck, be manually rotated and re-attached.
The toolbox and tonneau assemblies of the TruXedoPlus must be used together to form a complete kit. The tonneau portion of the TruXedoPlus is specifically made to work with the TruXedoPlus toolbox and will not work with an existing toolbox. If you have a TruXedo Plus system and need to replace just the toolbox or just the tonneau cover portion, you can order just the component you need.